为研究裂隙倾角对类岩石试样的强度与变形特性、裂纹扩展规律及破坏过程的变化趋势的影响，对含有不同倾角的预制裂隙类岩石试样进行霍普金森杆（SHPB）加载试验。研究发现，SHPB加载作用下类岩石试样的应变阶段分段不明显，基本不存在应变软化阶段以及残余强度段。SHPB加载作用下，类岩石试样的峰值强度的变化趋势与静载荷作用下基本相同。随着预制裂隙倾角变化呈先变大后减小的V字形变化。在裂隙倾角为45°时，试样的峰值强度最小，0°和90°试样的峰值强度与完整试样极其接近。且SHPB加载作用下的类岩石试样的强度增加比较缓慢，峰值强度基本都小于相同条件下静载荷的峰值强度。随着预制裂隙倾角的增大，起裂角逐渐减小。当预制裂隙倾角较小时（0°，15°），起裂角接近90°。与静载荷作用下的变化趋势是一致的。SHPB加载过程与静载荷不同，类岩石试样从开始加载至完全破坏总时间为约为2 s，速度极快。
In order to study the influence of the crack obliquity on the strength, the deformation, the crack propagation and the failure process of rocklike specimens, the SHPB loading test is carried out for rocklike specimens, with prefabricated cracks containing different inclinations. It is found that the strain phase segment is not obvious under the SHPB loading and the strain softening stage and residual strength section are almost of non-existence. Under the SHPB loading, the peak strength of the rock specimens is almost the same as that under the static loading, that is, it is in a V shape against the angle of the rocklike specimens and it increases before it decreases. The peak strength of the specimens is the minimum, when the crack obliquity is 45°, and the peak strength of the specimens is very close to that of the complete specimens when the crack obliquity is 0° or 90°. The strength of the rocklike specimens under the SHPB loading increases slowly and the peak strength is less than the peak strength under the static loading under the same condition. The crack angles decrease with the increase of the prefabricated crack inclinations. When the prefabricated crack inclinations are relatively small (0°,15°), the crack angle is close to 90°. This trend is consistent with the static loading. The SHPB loading process is different from that of the static loading, it lasts about 2s from the beginning of the loading to the complete failure of the rocklike specimens, with an extremely fast speed.
[1] 王明洋, 钱七虎. 爆炸应力波通过节理裂隙带的衰减规律[J]. 岩土工程学报, 1995, 17(20):42-46. Wang Mingyang, Qian Qihu. The attenuation law of explosive stress wave through joint fissure zone[J]. Journal of Geotechnical Engineering, 1995, 17(20):42-46.
[2] 蒲成志. 单抽压缩下类岩体裂隙材料断裂破坏机制的实验研究[D]. 长沙:中南大学, 2010. Pu Chengzhi. Experiment research on the fracture failure mechanism of rocklike material with fissures under uniaxial compression[D]. Changsha:Central South University, 2010.
[3] 张平, 李宁, 贺若兰. 含裂隙类岩石材料的局部化渐进破损模型研究[J]. 岩石力学与工程学报, 2006, 25(10):2043-2050. Zhang Ping, Li Ning, He Ruolan. Research on localized progressive damage model for fractured rocklike materials[J]. Chinese Journal of Rock Mechanics and Engineering, 2006, 25(10):2043-2050.
[4] 刘爱华, 郑鹏. SHPB在岩石动静组合加载实验中的应用及发展方向[J]. 爆破, 2007, 24:253-259. Liu Aihua, Zheng Peng. Application and future development of SHPB for rock test under static-dynamic loading[J]. Blasting, 2007, 24:253-259.
[5] Loeber J F, SIH G C. Diffraction of antiplane shear waves by a finite crack[J]. Acoustical Society of America, 1968, 44(1):90-98.
[6] Bagde M N, Petros V. The effect of machine behaviour and mechanical properties of intact sandstone under staticand dynamicuniaxial cyclic loading[J]. Rock Mechanics and Rock Engineering. 2005, 38(1):59-67.
[7] Yang Y F, Tang C A, Xia K W. Study on crack curving and branching mechanismin quasi-brittle materials under dynamic biaxial loading[J]. Int J Fract, 2012(177):53-72.
[8] 李地元, 成腾蛟, 周韬, 等. 冲击载荷作用下含孔洞大理岩动态力学破坏特性试验研究[J]. 岩石力学与工程学报, 2015, 34(2):249-260. Li Diyuan, Cheng Tengjiao, Zhou Tao, et al. Experimental study of the dynamic strength and fracturing characteristics of marble specimens with a single hole under impact loading[J]. Chinese Journal of Rock Mechanics and Engineering, 2015, 34(2):249-260.
[9] 王锦山, 黄明利. 含裂纹岩石受载后的应力场特征及其影响因素分析[J]. 山东科技大学学报(自然科学版), 2001, 20(2):90-94. Wang Jinshan, Huang Mingli. Stress field characteristics and its influence factors of the cracked rocks[J]. Journal of Shandong University of Science and Technology:Science and Technology, 2001, 20(2):90-94.
[10] 朱万成, 黄志平. 含预制裂纹巴西盘试样破裂模式的数值模拟[J]. 岩土力学, 2004, 25(10):1609-1613. Zhu Wancheng, Huang Zhiping. Numerical simulation of fracture mode of Brazil plate with prefabricated cracks[J]. Rock and Soil Mechanics, 2004, 25(10):1609-1613.
[11] 吴海, 杨栋. 类岩石材料裂纹演化机理的研究进展[J]. 太原理工大学学报, 2005, 36(增1):7-11. Wu Hai, Yang Dong. Research progress of the mechanism of crack evolution in rock like materials[J]. Journal of Taiyuan University of Technology, 2005, 36(Suppl 1):7-11.
[12] Wong R H C, Law C M, Chau K T. Crack propagation from 3-D surface fractures in PMMA and marble specimens under uniaxial compression[J]. International Journal of Rock Mechanics and Mining Sciences, 2004, 41:37-42.
[13] 朱万成, 逄铭璋. 含预制裂纹岩石试样在动载荷作用下破裂模式的数值模拟[J]. 地下空间与工程学报, 2005, 1(6):23-28. Zhu Wancheng, Jiang Mingzhang. Numerical simulation of failure mode of rock samples with prefabricated cracks under dynamic loading[J]. Journal of Underground Space and Engineering, 2005, 1(6):23-28.
[14] 陈瑜, 黄永恒, 曹平, 等.不同高径比时软岩强度与变形尺寸效应试验研究[J]. 中南大学学报(自然科学版), 2010(3):1073-1078. Chen Yu, Huang Yongheng, Cao Ping, et al. Experimental study on the strength and deformation of soft rock with different high diameter ratio[J]. Journal of Central South University:Science and Technology, 2010(3):1073-1078.
[15] 王卫华, 王小金, 姜海涛, 等. 单轴压缩作用下含不同倾角裂隙的类岩石试样力学特性[J]. 科技导报, 2014, 32(28/29):48-53. Wang Weihua, Wang Xiaojin, Jiang Haitao, et al. Experimental research on mechanical properties of rocklike specimens containing single cracks of different inclination anglesunder uniaxial compression[J]. Science and Technology Review, 2014, 32(28/29):48-53.
[16] 张海波. 动、静荷载作用下不同倾角裂隙岩体力学性能试验模拟研究[D]. 南京:河海大学, 2007. Zhang Haibo. Experimental simulation study on mechanical properties of rock mass with different dip angle under dynamic and static loads[D]. Nanjing:Hohai University, 2007.
[17] 蒲成志, 曹平, 赵延林, 等.单轴压缩下多裂隙类岩石材料强度试验与数值分析[J]. 岩土力学, 2010, 31(11):3661-3666. Pu Chengzhi, Cao Ping, Zhao Yanlin. Numerical analysis and strength experiment of rock-like materials with multi-fissures under uniaxial compression[J]. Rock and Soil Mechanics, 2010, 31(11):3661-3666.
